| Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
|---|---|---|
| Article Number | 01067 | |
| Number of page(s) | 4 | |
| Section | Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201822401067 | |
| Published online | 30 October 2018 | |
Efficiency improvement for assigning of cutting conditions on the basis of the thermo-EMF signal
Volgograde State Technical University, Linine Ave. 28, Volgograde 400005, Russia
* Corresponding author: tihonova-ganna@rambler.ru
In the realities of modern machine-building production, control and management of processes occurring in the cutting zone are of great importance. The acquisition of control will significantly improve the stability and quality of processing, and the possibility of monitoring will help to increase the economic efficiency of production. This article presents the potential of the thermo-emf signal in a natural thermocouple “tool – workpiece” which is considered to be an information signal from the cutting zone. It also shows experimental proof of the influence between honing width on the front surface of the tool and its size.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.