| Issue |
MATEC Web Conf.
Volume 129, 2017
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|
|
|---|---|---|
| Article Number | 01045 | |
| Number of page(s) | 3 | |
| Section | Modern Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201712901045 | |
| Published online | 07 November 2017 | |
Influence of the surface layer characteristics on the regularities of the cutting process
Volgograde State Technical University, Linine Ave. 28, Volgograde 400005, Russia
* Corresponding author: krainevdv@mail.ru
The article considers the influence of the surface layer characteristics on the regularities of the cutting process and the formation of the quality of the surface machined. This effect has been confirmed by the study results of the combined cutting method with advanced plastic deformation (APD). The work estimates the impact of the change in the surface layer properties on the forces and temperature of cutting, stability of the chip formation and quality parameters of the surface machined.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.