MATEC Web Conf.
Volume 343, 202110th International Conference on Manufacturing Science and Education – MSE 2021
|Number of page(s)||6|
|Section||Design, Manufacturing and Management of Technological Equipment and Systems|
|Published online||04 August 2021|
Study on the influence of technological parameters on 3D printing with sla technology
University “Aurel Vlaicu” of Arad, B-dul Revoluţiei Nr. 77, 310130, România.
* Corresponding author: firstname.lastname@example.org
The influence of the technological parameters of the printing through the SLA (Stereolithography) technology is presented. This printing technology is based on the use of a photosensitive resin, which polymerizes in contact with UV rays with a wavelength of 405nm. An Anycubic Photon Mono printer is used, on which parts are printed, in which the dimensional accuracy and the condition of the resulting surfaces will be analyzed. It will study the influence of the polymerization time of the resin (5s - 10s), of the advance step between the successively deposited layers (0.05mm - 0.2mm), as well as the influence of the placement positioning of the reference mark for printing. A Black basic type, monomer with photo-initiator photosensitive resin will be used made by Anycubic,. A Sony alpha 37 DSLR camera with Sony SAL-100M28 100mm F / 2.8 AF Macro lens will be used to capture images for the resulting surfaces.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.