MATEC Web Conf.
Volume 329, 2020International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2020)
|Number of page(s)||6|
|Published online||26 November 2020|
Modeling and research of the process of preparing the surface of a part for thermal spray coating
1 Orel State University named after I. S. Turgenev, Komsomolskaya st. 95, 302026, Orel, Russia
* Corresponding author: rоdfox@yandex.ru
The article presents an analysis of ways to increase the adhesive strength of antifriction coating. A rational method for the mechanical formation of surfaces is proposed. The calculation of the workpiece based on the finite element method has been carried out. The theoretical dependences of metal lifting on the depth of the rolling roller are obtained. The results of a field experiment are presented. A comparative analysis of theoretical and practical results of the research has been carried out. Recommendations are given for the further use of the net rolling method with a pre-cut “ragged thread”.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.