Issue |
MATEC Web Conf.
Volume 329, 2020
International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2020)
|
|
---|---|---|
Article Number | 03051 | |
Number of page(s) | 5 | |
Section | Mechanical Engineering | |
DOI | https://doi.org/10.1051/matecconf/202032903051 | |
Published online | 26 November 2020 |
Influence of the tool’s feed on the thickness of burrs at the pipe end during stack cutting with a circular saw
Volgograd State Technical University, 400005, Volgograd, Lenin avenue, 28, Russia
* Corresponding author: kinnomans@mail.ru
By means of mathematical modeling of the distribution of the temperature field in the workpiece during stack cutting of cold rolled metal, the results of heat distribution in the pipe material were obtained at various feeds S. The temperature field of the pipe material at feeds 0.008 m/ s (0.0012 mm / tooth) - 0.028 m / s (0.0042 mm / tooth) is studied when cutting a stack of blanks from workpieces with a diameter of 42 mm.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.