MATEC Web Conf.
Volume 329, 2020International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2020)
|Number of page(s)||8|
|Published online||26 November 2020|
Analysis of the geometry and contact density of globoid gearing
Department of Road Transport, Construction and Road Machines, Construction Institute, Industrial University of Tyumen, 625000 Tyumen, Volodarskogo St., 38, Russia
* Corresponding author: email@example.com
Globoid worm gears have been widely applied in a range of technological branches in which other types of worm gears are less effective. The main functional indicators which facilitated their popularity include high load capacity and durability, low vibroactivity and small energy losses. As the experience of application and the results of the study of globoid worm gears showed, the level of operational properties of globoid gears is higher than that of the others only if the gearing and technological parameters of their manufacturing are optimally chosen during the design stage. This paper describes a method for estimating the gearing parameters of a globoid gear with an account of the geometry of the elements (the geometry of the teeth of the wheel and the worm thread), namely the calculation of the gap fields in the globoid gearing by means of numerical methods.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.