MATEC Web Conf.
Volume 290, 20199th International Conference on Manufacturing Science and Education – MSE 2019 “Trends in New Industrial Revolution”
|Number of page(s)||10|
|Section||Design, Manufacturing and Management of Technological Equipment and Systems|
|Published online||21 August 2019|
Studies on wheel mounting options on shafts
Lucian Blaga University of Sibiu, Industrial Engineering and Management Department, Victoriei, 10, 550025, Sibiu, Romania
* Corresponding author: firstname.lastname@example.org
The paper presents a general description of chains and chain transmissions, their advantages and disadvantages. A triple chain wheel is then projected into the CATIA V5 program. A static analysis of some wheel mounting variants on a camshaft with the Generative Structural Analysis module in the CATIA V5 program is then made. The orientation-fastening variants with a wedge, two feathers or three screws positioned equidistant at 120 degrees on a diameter are analysed. As a result of the finite element analysis, the conclusion is that the three-screw variant is the most appropriate. Material stresses and deformations are smaller, simpler processability, fewer types of components are present overall, maintenance is simpler, and the excentricity of the assembly is lower, with lower vibrations in operation.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.