Issue |
MATEC Web Conf.
Volume 346, 2021
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2021)
|
|
---|---|---|
Article Number | 03074 | |
Number of page(s) | 6 | |
Section | Mechanical Engineering | |
DOI | https://doi.org/10.1051/matecconf/202134603074 | |
Published online | 26 October 2021 |
Investigation of the Influence of the Space Orientation of Layers on the Surface Shape Error during Additive Shaping of Products by an Electric Arc in a Protective Gases Environment
Southwest State University, 50 Years of October St., 94, Kursk, Russia
* Corresponding author: agrechunin@mail.ru
The paper presents the results of a study of the process of additive surface shaping by an electric arc in a protective gas. An analysis was made of the errors in the shape of surfaces obtained with different filling of layers. It has been experimentally confirmed that such process parameters as the orientation of the layers, the coefficient of their overlap are significant and affect the numerical value of the error in the shape of the resulting surface. In this connection, they should be taken into account when designing algorithms for dividing into layers and filling them with additive shaping by an electric arc in a protective gas.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.