MATEC Web Conf.
Volume 226, 2018XIV International Scientific-Technical Conference “Dynamic of Technical Systems” (DTS-2018)
|Number of page(s)||7|
|Section||1 Fundamentals of mechanics, dynamics and tribology of machines|
|Published online||07 November 2018|
Management of space orientation of the end effector of generation of geometry system fiveaxis manufacturing machinery for additive generation of geometry
Southwest State University, 305040 Kursk u.50 Let Oktyabrya 94, Russian Federation
* Corresponding author: firstname.lastname@example.org
The article is devoted to the investigation of the surface layer formation accuracy of engineering products by additive methods. The analysis of advantages and disadvantages of layered products synthesis technologies was carried out. It was revealed that, in additive shaping, the exact characteristics of the surface layer differ significantly from the accuracy characteristics of the surface layer of products obtained by the traditional methods. The analysis of domestic and foreign works on the topic of research was carried out. It is revealed that to increase the accuracy characteristics of products obtained by additive methods, it is necessary to realize dynamically the spatial orientation of the working element of the additive installation in the process of shaping. To control the spatial orientation of the working organ of additive equipment, a method is proposed. According to the proposed method, the controlled parameters of the additive installation are calculated on the basis of a 5- coordinate mechatronic system. The proposed methodology will allow to calculate the controlled parameters of the process equipment, to provide the required orientation of the working element of the additive installation to reduce the error of shaping (approximation), using 5-coordinate mechatronic system
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.