MATEC Web Conf.
Volume 329, 2020International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2020)
|Number of page(s)||5|
|Published online||26 November 2020|
Selection of the quantity of the allowance at rough treatment of large – size parts from titanium alloy of BT6 (Russian State Standard GOST 19807-91)
Kalashnikov Izhevsk State Technical University, 7 Studencheskaya street, Izhevsk 426069, Russian Federation
* Corresponding author: firstname.lastname@example.org
The article presents the results of experimental studies of the effect of cutting depth on cutting force and the procedure of assignment of allowance value at rough turning and melting of stamped blanks for large- size parts of rocket equipment from titanium alloy VT6. As a result of the studies carried out, empirical dependence of cutting force on cutting depth was obtained, and method of allocation of allowance value was created, which is very important in processing of large-size stamped blanks.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.