Issue |
MATEC Web Conf.
Volume 329, 2020
International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2020)
|
|
---|---|---|
Article Number | 01005 | |
Number of page(s) | 5 | |
Section | Transport | |
DOI | https://doi.org/10.1051/matecconf/202032901005 | |
Published online | 26 November 2020 |
The formation of residual stresses in the bonding of automotive glass
Samara state technical university, Russia
* Corresponding author: konferencia-isap@yandex.ru
This article discusses the formation of residual stresses during the assembly of automotive glass. The influence of various parameters of the adhesive bead on the spatial deviations of glasses during their installation is shown. Currently, the glass assembly technology involves filling the gap between the automotive glass and the car body with a glue roller. It has been established that the formation of residual stresses is influenced by the width and thickness of the glue roll, with a minimum width of the glue roll during drying, a discontinuity of the glue joint along the contour is possible, and with a maximum width, unacceptable residual deformations occur in the glass, which lead to cracks.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.