MATEC Web Conf.
Volume 298, 2019International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2019)
|Number of page(s)||5|
|Published online||18 November 2019|
The polymeric materials turning after workpiece processing with surface-active substances
Pacific National University, 680035 Khabarovsk, Russia
* Corresponding author: firstname.lastname@example.org
The results of experimental investigations of surface quality after the lathe machining of polymeric materials subjected to preliminary treatment with surface-active substances are presented. The new combined method for polymer parts was developed. This method is based on directed change in the polymer properties by preliminary chemical treatment of the surface layer so as to reduce its resistance in the cutting zone. It has been demonstrated in experiments that the preliminary treatment of workpiece with surfactants ensures an improvement in quality of the surface machined by turning. This is indicated by a reduction in the roughness parameters by a factor of 2–4.5, and the minimum roughness is achieved at a cut depth equal to 1.0–1.15 the surfactant penetration depth into the material
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.