| Issue |
MATEC Web Conf.
Volume 287, 2019
6th International BAPT Conference “Power Transmissions 2019”
|
|
|---|---|---|
| Article Number | 01023 | |
| Number of page(s) | 4 | |
| Section | Design, Analysis, Simulation and Optimization | |
| DOI | https://doi.org/10.1051/matecconf/201928701023 | |
| Published online | 14 August 2019 | |
Progress in the development of the cutting assemblies’ construction of working machines due to the reduction in power consumption
UTP University of Science and Technology in Bydgoszcz, Faculty of Mechanical Engineering, Al. prof. S. Kaliskiego 7, 85-796 Bydgoszcz, Poland
* Corresponding author: zastemp@utp.edu.pl
New construction of the cutting assembly developed at the Institute of Mechatronics and Working Machines of the University of Technology and Life Sciences in Bydgoszcz. That new construction is covered by the patent protection. The conducted and presented results of the experimental tests have shown, that it is characterised by lower power consumption as compared to the classical construction, which is commonly used in working machines.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.