| Issue |
MATEC Web Conf.
Volume 287, 2019
6th International BAPT Conference “Power Transmissions 2019”
|
|
|---|---|---|
| Article Number | 01024 | |
| Number of page(s) | 4 | |
| Section | Design, Analysis, Simulation and Optimization | |
| DOI | https://doi.org/10.1051/matecconf/201928701024 | |
| Published online | 14 August 2019 | |
Analysis of the cutting moments for the selected chopper’s cutting drums constructions
UTP University of Science and Technology in Bydgoszcz, Faculty of Mechanical Engineering, Al. prof. S. Kaliskiego 7, 85-796 Bydgoszcz, Poland
* Corresponding author: zastemp@utp.edu.pl
The analysis of the drum cutting assembly’s movement dynamics is presented in the article. The derived mathematical dependences describing the dynamic load, may be used at the stage of designing of these types of cutting assemblies and of their drive systems. The simulation calculations conducted on the derived mathematical dependences, allowed the authors to develop a computational tool for quick identification of the demand for power and forces operating in the drum cutting assemblies under the impact of changes in characteristic input quantities.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.