| Issue |
MATEC Web Conf.
Volume 287, 2019
6th International BAPT Conference “Power Transmissions 2019”
|
|
|---|---|---|
| Article Number | 01015 | |
| Number of page(s) | 10 | |
| Section | Design, Analysis, Simulation and Optimization | |
| DOI | https://doi.org/10.1051/matecconf/201928701015 | |
| Published online | 14 August 2019 | |
Interference of the profiles when meshing internal straight splines with gear shapers
Department of Theory of Mechanisms and Machines, University of Ruse, Ruse 7017, Bulgaria
The possibilities for cutting internal straight splines with gear shapers by internal meshing, without interference between meshed profiles, are shown in this article. The interference is an undesirable occurrence whereby the straight profile of the splines and the instrumental contour intersect with each other beyond the meshing line. As a result, the shaper teeth cut off a part of the splines’ straight profile and they are made with some defects. The research shows that the undesirable interference depends directly on the parameters of the splined opening and the number of shaper teeth. Also, it is determined that the interference can be avoided by reducing the number of shaper teeth and the height of the splines. Furthermore, the maximum number of shaper teeth for all standard splines for which the interference is absent, are defined in the article. The results are confirmed by computer simulations of the corresponding instrumental meshing.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.