Issue |
MATEC Web Conf.
Volume 226, 2018
XIV International Scientific-Technical Conference “Dynamic of Technical Systems” (DTS-2018)
|
|
---|---|---|
Article Number | 01025 | |
Number of page(s) | 6 | |
Section | 1 Fundamentals of mechanics, dynamics and tribology of machines | |
DOI | https://doi.org/10.1051/matecconf/201822601025 | |
Published online | 07 November 2018 |
Optimization of the flat stock cutting process by hydroabrasive jet
1 Don State Technical University, 344000 Rostov-on-Don, Russia
2 Southern Federal University, 347922 Taganrog, Russia
* Tamarkin M.A.: tehn_rostov@mail.ru
This article focuses on the key results of hydroabrasive flat stock cutting research. The forming process is described and its theoretical investigation is presented. The theoretical dependence for the roughness determination of the surface cut is set. Experimental results of the process investigation confirming their theoretical adequacy are put forward. The next steps of process optimization within the framework of modern production are allocated.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.