Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 04023 | |
Number of page(s) | 7 | |
Section | Modelling of Technical Systems. CAD/CAM/CAE Systems | |
DOI | https://doi.org/10.1051/matecconf/201822404023 | |
Published online | 30 October 2018 |
The approach of creating a particular postprocessor and using CNC measuring cycles
FSBEI HPE MSTU “STANKIN”, Moscow, Russia
* Corresponding author: anna.stas2015@yandex.ru
The article is devoted to research, development and testing of the postprocessor for the CNC system. In the article was made a comparison between the methods for creating postprocessors, was described the development of a postprocessor and of the cycle of determining the diameter of the shaft and the coordinates of its center, used in testing postprocessor. In the work are demonstrated the tests of the developed postprocessor. As a result, after the work of the postprocessor, there is a finished NC for the CNC system.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.