| Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
|---|---|---|
| Article Number | 01065 | |
| Number of page(s) | 8 | |
| Section | Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201822401065 | |
| Published online | 30 October 2018 | |
Numeric simulation of aircraft engine parts additive manufacturing process
1
Perm national research polytechnic university, Computation Mathematics and Mechanics Department 29, Komsomolsky prospect, Perm, 614990, Russian Federation
2
JSC UEC-Aviadvigatel, Simulation department, 93, Komsomolsky ave., Perm, 614990, Russian Federation
* Corresponding author: dubrovskaya-as@avid.ru
This paper presents the results of software (ANSYS software) improvements specific for modeling the physical process of SLM (Selective Laser Melting). Improvement goal was to create a set of mathematical models and user environment (a set of APDL programs) based on the ANSYS finite element analysis system solver, allowing to perform the technological procedure of physical SLM process numerical modeling to the required degree of precision with an estimate of the final distortion and residual stresses of gas turbine engine parts to optimize the manufacturing process.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.