| Issue |
MATEC Web Conf.
Volume 346, 2021
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2021)
|
|
|---|---|---|
| Article Number | 01039 | |
| Number of page(s) | 6 | |
| Section | Materials Processing Technologies | |
| DOI | https://doi.org/10.1051/matecconf/202134601039 | |
| Published online | 26 October 2021 | |
Investigation of the Finishing Technology of SLM Implants
Perm National Research Polytechnic University, 29 Komsomolsky Prospect, Perm, 614990, Russian Federation
* Corresponding author: lowrider11-13-11@mail.ru
In this research, the use of plasma electrolytic polishing (PEP) as a finishing treatment of materials obtained by the SLM method from CoCr30 cobalt-chromium powder is proposed. To assess the possibility of using this method, a simulator sample was used. The imitation sample was polished for 60 seconds. The roughness and the size of the removal material were measured. Based on the results obtained for the simulator sample, a conclusion was made about the possibility of using PEP technology for finishing the treatment stent. The stent simulator was also polished. The processing time was 30s and 60s. The geometric parameters were measured, and the removal material was calculated. Images of the stent surface were taken before and after PEP. It was found that with an increase in the processing time from 30 to 60 seconds, the allowance removed from all surfaces increases almost twice. The possibility of using the PEP technology as a finishing operation for the manufacture of stents from cobalt-chromium alloys is shown.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.