Wear characteristics of die surface in deep drawing of stainless steel 304 by using finite element simulation

Numchoak Sabangban; Warit Sirikun; Krittatee Sangounsak; Sedthawatt Sucharitpwatskul

doi:10.1051/matecconf/201819201040

All issues

Volume 192 (2018)

MATEC Web Conf., 192 (2018) 01040

Abstract

Open Access

Issue		MATEC Web Conf. Volume 192, 2018 The 4^th International Conference on Engineering, Applied Sciences and Technology (ICEAST 2018) “Exploring Innovative Solutions for Smart Society”


Article Number		01040
Number of page(s)		4
Section		Track 1: Industrial Engineering, Materials and Manufacturing
DOI		https://doi.org/10.1051/matecconf/201819201040
Published online		14 August 2018

MATEC Web of Conferences 192, 01040 (2018)

Wear characteristics of die surface in deep drawing of stainless steel 304 by using finite element simulation

Numchoak Sabangban¹, Warit Sirikun¹, Krittatee Sangounsak¹ and Sedthawatt Sucharitpwatskul²

¹ Department of Industrial Engineering, Faculty of Engineering, Nakhon Phanom University 48000
² National Metal and Materials Technology Center (MTEC), Thailand Science Park, Pathum Thani 12120

Abstract

The characteristics of adhesive wear of TiN coating in drawing process by using finite element method were carried out to investigate the effects of drawing angles and sliding velocities of punch to explained wear index. Bending radius of die was used to increase the contact pressure between stainless sheet and TiN coating surface. Three sliding velocities (0.5, 1 and 5 mm/s) were studied each bending angle between (0^O to 90^O) by keeping the hardness of material coating to 24 GPa (HV.0.05). The results showed that the wear index were decreased with drawing angle but sliding speed of punch was not affected in slightly speed.

This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.