Issue |
MATEC Web Conf.
Volume 183, 2018
12th International Conference Quality Production Improvement – QPI 2018
|
|
---|---|---|
Article Number | 03011 | |
Number of page(s) | 4 | |
Section | Quality Management | |
DOI | https://doi.org/10.1051/matecconf/201818303011 | |
Published online | 31 July 2018 |
Analysis of production incompatibilities and risk level in series production of assembly elements for the automotive industry
Częstochowa University of Technology, Department of Production Engineering and Safety, Armi Krajowej Str. 19B, Częstochowa, Poland
* Corresponding author: magdalena.mazur@wz.pcz.pl
The paper presents issues connected to risk analysis of production incompatibilities occurrence. Low-pressure cords thermoforming process analysis was presented, as well as analysis of types of incompatibilities during the phase of marking product (pad printing). The risk analysis is based on three factors: occurrence, detection, and severity of a specific incompatibility. 6 incompatibility types were defined and their various causes were determined. One critical incompatibility was determined, as well as 4 severe production problems. Presented analysis is an element of implementation of project of new products into the existing thermoforming processes.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.