Issue |
MATEC Web Conf.
Volume 183, 2018
12th International Conference Quality Production Improvement – QPI 2018
|
|
---|---|---|
Article Number | 03006 | |
Number of page(s) | 6 | |
Section | Quality Management | |
DOI | https://doi.org/10.1051/matecconf/201818303006 | |
Published online | 31 July 2018 |
Using 5W-1H and 4M Methods to Analyse and Solve the Problem with the Visual Inspection Process - case study
Technical University of Czestochowa, Faculty of Management, Department of Production Engineering and Safety, 42-200 Czestochowa, Poland
* Corresponding author: krzysztof.knop@wz.pcz.pl
The article presents a case study on the use of specially prepared 5W-1H and 4M sheets for the analysis of the problem during the visual inspection process of the electric device, in order to solve it. The identified problem was related to inconsistent assessments during the visual (alternative) inspection of chamber gaps of the electric switch. The research methodology was presented the same as results confirming the effectiveness of the problem analysis in the area of quality control by using these two methods of Lean and WCM concepts. The article aimed to show that a skilful and pragmatic approach to the problem supported by appropriate tools can contribute to its effective solution.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.