| Issue |
MATEC Web Conf.
Volume 178, 2018
22nd International Conference on Innovative Manufacturing Engineering and Energy - IManE&E 2018
|
|
|---|---|---|
| Article Number | 01016 | |
| Number of page(s) | 6 | |
| Section | Advanced Machining and Surface Engineering | |
| DOI | https://doi.org/10.1051/matecconf/201817801016 | |
| Published online | 24 July 2018 | |
Analysis of chip formation and cutting forces in end milling AISI D2 tool steel with different cutting tool geometries
University “Ştefan cel Mare” from Suceava, Department of Mechanics and Technology, 720229 Universităţii Street 13, Romania
* Corresponding author: irina.besliu@usv.ro
The purpose of this study was to investigate and establish the correlations between milling tool geometry, cutting conditions, as input factors and the cutting forces variations and chips formation, as output factors when end milling of AISI D2 tool steel. The experiments were carried out using a Taguchi design array. The chip shape and microstructure and cutting force components were analyzed. The results of the study show that the cutting tool geometry has a great influence over segmented chip formation mechanism and cutting force levels.
© The Authors, published by EDP Sciences, 2018.
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.