| Issue |
MATEC Web Conf.
Volume 157, 2018
Machine Modelling and Simulations 2017 (MMS 2017)
|
|
|---|---|---|
| Article Number | 04004 | |
| Number of page(s) | 7 | |
| Section | Advanced industrial, automotive and green energy applications | |
| DOI | https://doi.org/10.1051/matecconf/201815704004 | |
| Published online | 14 March 2018 | |
Improving the quality of cutting flat glass
1
Faculty of Pruduction Technology and Management Jan Evangelista Purkyně University in Ústí nad Labem, Department of Machines and Mechanics, 400 96, Pausterova 1, Ústí n/L, Czech Republic
2
Faculty of Mechanical Engineering, Univerzity of Zilina. Univerzitna 1, 010 26 Zilina. Slovak Republic
* Corresponding author: svoboda@fvtm.ujep.cz
The article deals with improving the quality of the cut flat glass. The aim of the study was to determine mechanism of origin temporary and permanent stress in the glass. This affects the quality of the cut flat glass. Of the commonly measured process parameters were adjusted following an evaluation, better cooling of flat glass between the furnace and the point of cutting into a prescribed format glass. The results are applicable for flat glass production lines.
Key words: flat glass / float system / measurement / stress
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.