| Issue |
MATEC Web Conf.
Volume 157, 2018
Machine Modelling and Simulations 2017 (MMS 2017)
|
|
|---|---|---|
| Article Number | 02044 | |
| Number of page(s) | 9 | |
| Section | Modelling and simulation, structural optimization | |
| DOI | https://doi.org/10.1051/matecconf/201815702044 | |
| Published online | 14 March 2018 | |
Analysis of the influence of the pipe’s wall thickness on the corrugation of the surface during inductive bending of pipes
1
University of Zilina, Faculty of Mechanical Engineering, Department of Applied Mechanics, Univerzitná 1, 010 26, Zilina, Slovak Republic
2
Triple D Bending, 4707 Glenmore Trail SE, Calgary, Canada
* Corresponding author: milan.saga@fstroj.uniza.sk
The paper presents a calculation model for simulation the technological process of inductive bending of pipes. In the case of an incorrect combination of geometric bending parameters (pipe diameter, bend radius and pipe wall thickness) occurs the corrugation of the inner part in the pipe bend. The proposed calculation model for the ADINA FE software allows for a relatively short time and at low cost to predict the emergence of corrugation.
Key words: finite element analysis / induction bending / pipes / wall thickness / surface corrugation
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.