| Issue |
MATEC Web Conf.
Volume 137, 2017
Modern Technologies in Manufacturing (MTeM 2017 - AMaTUC)
|
|
|---|---|---|
| Article Number | 05002 | |
| Number of page(s) | 6 | |
| Section | Metal Forming | |
| DOI | https://doi.org/10.1051/matecconf/201713705002 | |
| Published online | 22 November 2017 | |
The lack of uniformity of the deformations and the degree of deforming in case of orbital deformation
Technical University of Cluj Napoca, Manufacturing Engineering Department, ROMANIA
* Corresponding author: sorin.grozav@tcm.utluj.ro
The degree of deformation and the lack of uniformity of the deformations are two important factors orbital deformity. The degrees of deformation in the case of orbital oscillating deformation between 40 and 70%, is much higher than in conventional methods. Two other important parameters that may change unevenness strains are axial force and advance. Their influence can be seen from the diagrams unevenness, and hence the higher the value of these parameters is reduced unevenness strains.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.