Issue |
MATEC Web Conf.
Volume 137, 2017
Modern Technologies in Manufacturing (MTeM 2017 - AMaTUC)
|
|
---|---|---|
Article Number | 01007 | |
Number of page(s) | 6 | |
Section | Manufacturing Engineering | |
DOI | https://doi.org/10.1051/matecconf/201713701007 | |
Published online | 22 November 2017 |
Research Regarding the Influence of Execution, Assembly and Functioning Errors on the Teeth Profile Modification of Spur Gear in Front Plane
Technical University of Cluj-Napoca, Manufacturing Engineering Department, 103-105 Muncii Bvd. Cluj-Napoca, Romania
* Corresponding author: borzan_cristina@ymail.com
The paper presents general aspects related to the influence of execution, assembly and functioning errors on the teeth profile modification from the spur gear in the front plane, in the case when the gear is fixed to the shaft in an asymmetrical position relative to the bearings. The numerical researches were done with FEM.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.