| Issue |
MATEC Web Conf.
Volume 121, 2017
8th International Conference on Manufacturing Science and Education – MSE 2017 “Trends in New Industrial Revolution”
|
|
|---|---|---|
| Article Number | 03011 | |
| Number of page(s) | 7 | |
| Section | Advanced Manufacturing Technologies | |
| DOI | https://doi.org/10.1051/matecconf/201712103011 | |
| Published online | 09 August 2017 | |
Tool life of diamond inserts after laser assisted turning of cemented carbides
Poznan University of Technology, Institute of Mechanical Technology, Piotrowo 3, 60-965, Poznan, Poland
* Corresponding author: piotr.a.kieruj@doctorate.put.poznan.pl
The paper presents results and discussion on parameters influence on tool life when turning laser cladded cemented carbides under laser assisted machining (LAM) conditions. The layers are known as Technolase 30S. This material is widely recognized as hard-to-cut. The experimental investigation was carried out with diamond inserts. The laser power density, feed rate and laser scanning speed were analysed. Flank wear (VBc) indicator was measured and cutting tool life was calculated. It was proved that Technolase 30S can be machined with LAM technology. The laser enhanced turning is more efficient than conventional turning and grinding.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.