MATEC Web Conf.
Volume 108, 20172017 International Conference on Mechanical, Aeronautical and Automotive Engineering (ICMAA 2017)
|Number of page(s)||5|
|Section||Control Theory and Technology|
|Published online||31 May 2017|
Characteristics of Timbers Dried Using Kiln Drying and Radio Frequency-Vacuum Drying Systems
1 Wood Drying Laboratory, Forest Research Institute Malaysia, 52109 Kepong, Selangor Darul Ehsan, Malaysia
2 Timber Engineering Laboratory, Forest Research Institute Malaysia, 52109 Kepong, Selangor Darul Ehsan, Malaysia
Heavy hardwoods are difficult-to-dry timbers as they are prone to checking and internal stresses when dried using a conventional kiln drying system. These timbers are usually dried naturally to reach 15% to 19% moisture content with an acceptable defects. Besides long drying time, timbers at these moisture contents are not suitable for indoor applications since they will further dry and causing, for example, jointing and lamination failures. Drying to a lower moisture content could only be achieved in artificial drying kilns such as conventional kiln, dehumidification kiln, solar kiln, radio frequency-vacuum, etc. The objective of this study was to evaluate the characteristics of 30 mm and 50 mm thick kekatong (Cynometra spp.) timber dried using kiln drying (KD) and radio frequency-vacuum drying (RFV) system. The investigation involved drying time, moisture content (MC) variations between and within boards, drying defects, shrinkage, and drying stress. Drying defects include checks (surface, end, and internal checks) and warping (bowing, cuping, spring, and twisting). The results showed that RFV drying time was reduced to 50% compared to the KD. RFV dried boards demonstrated a more uniform MC between and within boards. Shrinkage in width and thickness, as well as tangential/radial and volumetric shrinkages were substantially less in RFV boards. The amount of cupping, bowing and spring were very low and negligible in all drying runs. There was no twisting observed in all drying methods. The number of stress-free RFV board was higher than KD. With proper procedure, the RFV technology could be used for drying heavy hardwoods which are difficult to dry in conventional kilns due to excessive drying times and degradation.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.