| Issue |
MATEC Web Conf.
Volume 108, 2017
2017 International Conference on Mechanical, Aeronautical and Automotive Engineering (ICMAA 2017)
|
|
|---|---|---|
| Article Number | 02009 | |
| Number of page(s) | 4 | |
| Section | Material Analysis and Processing | |
| DOI | https://doi.org/10.1051/matecconf/201710802009 | |
| Published online | 31 May 2017 | |
Utilization of abrasive water jet for cutting parts of intricate shapes
1 Mechanical Engineering Department, Tafila Technical University, Amman, Jordan
2 Mechanical and Industrial Engineering Department, Applied Science University, Amman, Jordan
As early as 1974 the British Hydrodynamic Research Association, BHRA, held the First International Conference on Cutting by Water Jets. The subject was at its early stages. Since then a large amount of research work has been carried out and the process has been greatly developed. In this paper, utilization of water jets for flexible cutting parts of intricate shapes in steel plates and granite is presented and discussed.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.