Issue |
MATEC Web Conf.
Volume 104, 2017
2017 2nd International Conference on Mechanical, Manufacturing, Modeling and Mechatronics (IC4M 2017) – 2017 2nd International Conference on Design, Engineering and Science (ICDES 2017)
|
|
---|---|---|
Article Number | 02013 | |
Number of page(s) | 6 | |
Section | Chapter 2: Engineering Simulation, Modeling and Mechatronics | |
DOI | https://doi.org/10.1051/matecconf/201710402013 | |
Published online | 14 April 2017 |
Comparison of a 10 DOF quarter vehicle model with the FE analysis of tire impact against a road obstacle
Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, 10002, Croatia
a Corresponding author: nenad.kranjcevic@fsb.hr
In order to investigate the dynamic behaviour of tires on extreme irregularities on the road, a 10 degrees of freedom lumped 2D quarter vehicle model, comprising the two point rigid ring follower tire model, is presented and implemented in Matlab Simulink. The simulation results of tire impact against a step on the road, at various speeds and step heights, are compared to the results achieved by the FE analysis of the same problem.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.