Statics and Modal Analysis of Main Frame of Composite Board Detaching Sleeve Equipment

School of Mechanical Engineering, Sichuan University of Science and Engineer, Sichuan, China

^* Corresponding author: 568092170@qq.com

Abstract

A new type of special machine tool for stripper sleeve was developed according to the stripper sleeve process of composite board. In order to ensure the reliability of the mainframe structure and the performance of the linear guide mechanism, the static structural analysis and modal analysis of the mainframe are carried out. The results show that the maximum stress of the supporting beam under the main frame is about 48.18 MPa, the maximum strain is 0.00023, and the maximum stress of the four-legged column is about 5.35 MPa, which is full of strength and stiffness design requirements. The end-cutting mechanism is installed on the beam through the installation plate. The deformation of the beam has a great influence on the operation accuracy of the linear guide mechanism and the cutting accuracy of the end-cutting mechanism. The maximum displacement in the X and Y directions of the installation plate is 0.014 mm, 0.030 mm and 0.197 mm, respectively, which meets the normal use requirements and cutting accuracy requirements of the linear guide mechanism. The first six natural frequencies of the mainframe are 2.963 – 47.137 Hz. In order to make the mainframe have good dynamic characteristics, avoid resonance and meet the end-cutting requirements of the composite board, the motor speed should be controlled between 300 – 493 r / min.