| Issue |
MATEC Web Conf.
Volume 321, 2020
The 14th World Conference on Titanium (Ti 2019)
|
|
|---|---|---|
| Article Number | 11048 | |
| Number of page(s) | 6 | |
| Section | Microstructure - Properties Relationships | |
| DOI | https://doi.org/10.1051/matecconf/202032111048 | |
| Published online | 12 October 2020 | |
Influence of Microstructures on Tensile Properties at 400℃ of TC4 Titanium Alloy
Western Superconducting Technologies Co.， Ltd， Xi’an 710018， China
The effects of primary α phase volume fraction on the tensile properties at 400℃ of TC4 titanium alloy was studied by different solution temperature(Tβ-(10~80)℃). The effects of the thick of secondary α phase on the tensile properties at 400℃ of TC4 titanium alloy was studied by different cooling speed after solution treatment (water quench, air cooling, furnace cooling). The results show that with the decrease of primary α phase, the tensile and yield strength increase up, but the ductility has a little change. The thick of secondary α phase increases with the deceases of cooling speed after solution treatment, highest tensile and yield strength by water quench, the tensile strength of air cooling and furnace cooling were basically the same, but the yield strength of furnace cooling was 40MPa lower than air cooling. Therefore, the influence of the primary α phase volume fraction on the tensile strength at 400℃ was particularly obvious, we can control solution treatment and cooling way in combination with different requirements.
Key words: TC4 titanium / solution temperature / tensile properties at 400℃ / microstructure
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.