Issue |
MATEC Web Conf.
Volume 278, 2019
2018 2nd International Conference on Building Materials and Materials Engineering (ICBMM 2018)
|
|
---|---|---|
Article Number | 02001 | |
Number of page(s) | 5 | |
Section | Surface Treatment and Coating Technology | |
DOI | https://doi.org/10.1051/matecconf/201927802001 | |
Published online | 08 April 2019 |
Wear Mechanism of Multi-layer AlCrWN/AlCrWSiN Coatings on Cemented Carbide Tool Prepared by Arc Ion Plating in Dry Cutting of Sintered Steel
1
Nara National College of Technology, Department of Mechanical Engineering, 22 Yata-cho, Yamatokoriyama 639-1080, Japan
2
OSG Corporation, Japan
To clarify the effectiveness of multi-layer AlCrWN/AlCrWSiN-coated cemented carbide tools, the wear progress was investigated in cutting sintered steel using three types of coated tool. Tool I had a mono-layer (Al60,Cr25,W15)N-coating film, Tool II had a mono-layer (Al53,Cr23,W14,Si10)N-coating film and Tool III had a multi-layer (Al60,Cr25,W15)N/(Al53,Cr23,W14,Si10)N-coating film. The following results were obtained: (1) The main tool failure of the three types of coated tools was flank wear within a maximum value of flank wear width of 0.2 mm. (2) The wear progress of Type III, which was a multi-layer coating system, was the slowest in cutting sintered steel.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.