MATEC Web Conf.
Volume 269, 2019IIW 2018 - International Conference on Advanced Welding and Smart Fabrication Technologies
|Number of page(s)||7|
|Published online||22 February 2019|
Welding Cylinder Head: The Effect of Filler Variations and Post Weld Heat Treatment (PWHT) on Microstructure and Mechanical Properties on TIG Welded Cast Iron FC 250
Materials and Metallurgical Engineering, Faculty of Industrial Technology, Institut Teknologi Sepuluh Nopember (ITS), Surabaya 60111, Indonesia
Corresponding author: firstname.lastname@example.org
Cylinder head made from grey cast iron, is one of critical engine part which work on high temperature and pressure. The condition which occurs continuously during engine operation causes wear which identified as a fretting failure. Therefore repairing process is needed by using Tungsten Inert Gas (TIG) welding. By considering the working condition and the materials, welding parameters are used 140A current, 100% Argon, DCEP and preheat at 250°C. The welding process is done on specimen sample of cylinder head which fretting failure by using Ni-CI, NiFe, NiFe-1 dan 308L filler variation for each specimen and done by PWHT at temperature 650°C which holding time 90 minutes. Visual test, macroscopic test, microscopic test and hardness test already done in this research. The results are there is no defect such as crack, porosity, undercut, and lack of fusion on the visual and macroscopic test. On microscopic test, there is the brittle phase (martensite) in HAZ at Non-PWHT specimen, but after PWHT the martensite transform became martempered phase. FC250 standard hardness value is about 170-235HB, and the result is the hardness value of non-PWHT specimen higher than the standard in HAZ, and the high hardness value of PWHT specimen on weld metal by using NiFe, NiFe-1 and 308L. So from the filler variation, Ni-CI filler with PWHT is on standard either on phase or on hardness value
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.