Issue |
MATEC Web Conf.
Volume 254, 2019
XXIII Polish-Slovak Scientific Conference on Machine Modelling and Simulations (MMS 2018)
|
|
---|---|---|
Article Number | 05006 | |
Number of page(s) | 6 | |
Section | Experimental Mechanics, Identification and Validation | |
DOI | https://doi.org/10.1051/matecconf/201925405006 | |
Published online | 15 January 2019 |
Correlation image system 3D DANTEC as a modern system for measuring deformation
Czestochowa University of Technology, Institute of Mechanics and Machine Design Foundations, Czestochowa, Poland, UE
* Corresponding author: domanski@imipkm.pcz.pl
The work presents the possibilities created by the multi-camera 3D image correlation system. The experience is based on non-contact measurement of displacements and deformations. The measurement was used basically to estimate the deflection line of the bending beams and values of strains and displacements at various points of the cross-section. The measurement was carried out by tracking the displacements of the prepared surface of the sample. The results of the numerical analysis were also presented, which were compared with the experience carried out on the measurement stand.
Key words: image correlation system / strains / deformations / bending test
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.