Issue |
MATEC Web Conf.
Volume 254, 2019
XXIII Polish-Slovak Scientific Conference on Machine Modelling and Simulations (MMS 2018)
|
|
---|---|---|
Article Number | 02003 | |
Number of page(s) | 6 | |
Section | Modelling and Simulation, Structural Optimization | |
DOI | https://doi.org/10.1051/matecconf/201925402003 | |
Published online | 15 January 2019 |
Conversion of data from the laser scanner to the Ansys Workbench
1
Department of Applied Mechanics, Faculty of mechanical engineering, University of Žilina, Univerzitná 8215/1, 010 26 Žilina, Slovak Republic
2
Schaffler Slovakia, Dr G Schaefflera 1, Kysucke Nove Mesto, Slovak Republic
* Corresponding author: Ondrej.Stalmach@fstroj.uniza.sk
This paper deals with the data processing in the form of a cloud of points scanned using a handheld 3D laser scanner. The aim of this paper is to use this data to create a representative FEM model and compare two different approaches while one of them involves creating a CAD model and the other one not. The data processing is carried out in the freeware systems MeshLab and Meshmixer and FEM analysis in the software ANSYS Workbench.
Key words: 3D laser scanner / data processing / CAD model / MeshLab / Ansys Workbench
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.