| Issue |
MATEC Web Conf.
Volume 157, 2018
Machine Modelling and Simulations 2017 (MMS 2017)
|
|
|---|---|---|
| Article Number | 02038 | |
| Number of page(s) | 6 | |
| Section | Modelling and simulation, structural optimization | |
| DOI | https://doi.org/10.1051/matecconf/201815702038 | |
| Published online | 14 March 2018 | |
Numerical simulation of blanking process
University of Žilina, Faculty of Mechanical Engineering, Department of Applied Mechanics, Univerzitná 8215/1, 01026 Žilina, Slovak Republic
* Corresponding author: peter.pechac@fstroj.uniza.sk
This paper presents numerical simulation of blanking process for cold-rolled steel sheet metal. The problem was modeled using axial symmetry in commercial finite element software ADINA. Data obtained by experimental measurement were used to create multi-linear plastic material model for simulation. History of blanking force vs. tool displacement was obtained.
Key words: blanking / plasticity / axial symmetry / rupture / contact / nonlinear static analysis
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.