| Issue |
MATEC Web Conf.
Volume 226, 2018
XIV International Scientific-Technical Conference “Dynamic of Technical Systems” (DTS-2018)
|
|
|---|---|---|
| Article Number | 03027 | |
| Number of page(s) | 8 | |
| Section | 3 Issues of creation and mechanics of heterogeneous and composite materials | |
| DOI | https://doi.org/10.1051/matecconf/201822603027 | |
| Published online | 07 November 2018 | |
On a method for determination of Poisson’s ratio and Young modulus of a material
1 Research and Education Center “Materials”, Don State Technical University, 344000 Rostov-on-Don, Russia
2 Mathematical Modeling Department, Southern Federal University, 344006 Rostov-on-Don, Russia
* Corresponding author: rainesquall@icloud.com
On the base of modernized NanoTest 600 Platform 3 indentation method is proposed to determine elastic parameters – Poisson’s ratio and Young’s modulus – of a material while loading in an elastic region. The experiment is based on procedure: lateral surface of indenter tip with the shape of parabolic cylinder penetrates into the specimen. NanoTest 600 was equipped by additional optics, backlight and device for spatial orientation of the specimen. This modernization allows to control the process of the indenter penetration both along its length and from the edges, so that one can observe and measure the width of the contact area and control the depth of the indentation area in a sample material. Mathematical modeling of the indentation process was conducted within the framework of plane theory of elasticity. This required solution of the contact problem on indentation of a rigid indenter with a parabolic shape into an elastic strip coupled with a non-deformable substrate. The fulfilment of condition of zeroing the contact stresses at the edges of the indenter with a known width of the contact area allows to determine the Poisson’s ratio, and condition of static equilibrium of the contact problem helps to find Young’s modulus of a strip material.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.