MATEC Web Conf.
Volume 108, 20172017 International Conference on Mechanical, Aeronautical and Automotive Engineering (ICMAA 2017)
|Number of page(s)||5|
|Section||Material Analysis and Processing|
|Published online||31 May 2017|
Research on the Test Method of Machining Stress Based on the Instrumented Indentation Test
College of Mechanical Engineering and Applied Electronics Technology, Beijing University of Technology, Beijing, 100124, China
The main objective of this study is to measure the distribution of machining stress by the instrumented indentation test (IIT). Finite element method (FEM) was performed to investigate the influences of tensile stress and compression stress on the indentation response (Load-displacement curves, average contact pressure and contact area). The thicknesses of machining stress layer under turning and grinding processing ways were obtained by layer stripping method based on instrumented indentation technique. Results indicate that the machining stress brings complex stress state. Under the same load, the corresponding indentation displacement increases while the indentation plastic work, contact area and average contact pressure decrease with the increases of machining stress (from compressive stress to tensile stress). Tensile stress does just the opposite. In addition, the layer thicknesses of the machining stress for turning and grinding members were measured by instrumented indentation method, results agree with X-ray method and demonstrate the effectiveness of the proposed approach.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.