MATEC Web Conf.
Volume 226, 2018XIV International Scientific-Technical Conference “Dynamic of Technical Systems” (DTS-2018)
|Number of page(s)||6|
|Section||1 Fundamentals of mechanics, dynamics and tribology of machines|
|Published online||07 November 2018|
The active working shoot modeling profile of the centrifugal microturbine
1 South-Russian State Polytechnic University (Novocherkassk Polytechnic Institute) M.I. Platova, 346400 Novocherkassk, Russia
2 Kuban State University, 350040 Krasnodar, Russia
* Corresponding author: email@example.com
For the small distributed power, microturbines of electric 30-500 kW capacity are used: gas piston engines, gas and steam turbines, each of which has certain advantages and disadvantages. In the work, the active working blade profile is simulated for a single-stage, two-stream, centripetal microturbine, in order to determine the optimum profile design satisfying the reliability conditions and economy. The basis is a humidsteam microturbine of a horizontal electric version with a capacity of 30 kW. The initial data for software simulation were the microturbineactive stage characteristics, determined by the steam turbines calculation traditional methods.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.