Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 03005 | |
Number of page(s) | 8 | |
Section | Materials science | |
DOI | https://doi.org/10.1051/matecconf/201822403005 | |
Published online | 30 October 2018 |
Research of structural entropy of sheet aluminium alloys depending on annealing temperature
1
Samara University, Metal Technology and Aviation Material Science Department, 34, Moskovskoye shosse, Samara, 443086, Russia
2
Samara University, Metal Pressure Working, 34, Moskovskoye shosse, Samara, 443086, Russia
* Corresponding author: eanosova@mail.ru
Sheet blanks’ structure uniformity determines their ability to sheet stamping. Level of entropy may represent the characteristic of structural uniformity. Structural entropy was received from strain curves recalculation for sheet blanks from aluminium alloys Al-2Mg and Al-6Mg are presented in the work. Stain curves were provided for blanks after cold deformation and annealing at temperatures 250, 350 И 450˚C. Estimation of grain size uniformity was made. Effect of annealing temperature on structural entropy and grain structure uniformity was found. It was shown that annealing temperature increasing leads to structural entropy decreasing. Ununiformity of grain size achieves the minimal values after annealing at temperature 350˚C for both alloys, and then ununiformity grows after annealing at temperature 450˚C.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.