MATEC Web Conf.
Volume 129, 2017International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|Number of page(s)||4|
|Section||Advanced Materials and Coatings|
|Published online||07 November 2017|
Multi-cycle rolled aluminum alloy 3103 sandwiches: mechanical properties and stamp ability
Samara University, Metal Technology and Aviation Material Science Department, 443086, Moskovskoye shosse, 34, Samara, Russia
2 Samara University, Metal Pressure Working, 443086, Moskovskoye shosse, 34, Samara, Russia
* Corresponding author: firstname.lastname@example.org
Constructional part producing by sheet stamping of multilayer composites requires the stamping ability data. The aim of a work is to estimate mechanical properties, stamping ratio and anisotropy indexes of 2, 4, 8 and 12 layer sandwiches produced from aluminium alloy AA3103. The pieces were received by the cold rolling. Interoperation annealing was at 500°C for 1 hour. Charts of tensile strength, yield stress, elongation depending on layer thickness were composed. It was found that cold strain hardening does not disappear after annealing if the foil’s thickness become 0.4 mm and less. Microstructure analysis has shown a good contact between layers for all samples and thicker outer layers.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.