| Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
|---|---|---|
| Article Number | 02074 | |
| Number of page(s) | 7 | |
| Section | General problems of mechanical engineering: design, optimization, maintenance | |
| DOI | https://doi.org/10.1051/matecconf/201822402074 | |
| Published online | 30 October 2018 | |
Analysis of the applicability of die pressing method for ring-shaped parts fabrication
Bauman Moscow State Technical University, 5 2ya Baumanskaya Str., 105005, Moscow
* Corresponding author: artemdrezna@mail.ru
This paper analyses die pressing method used for fabrication of ring-shaped parts, which assures significant metal economy. Computer simulation results obtained with PAM-STAMP software are compared with experimental data. The research outcome is the established range of applicability of die-pressing method for manufacturing ring-shaped parts.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.