Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 01135 | |
Number of page(s) | 6 | |
Section | Manufacturing Technologies, Tools and Equipment | |
DOI | https://doi.org/10.1051/matecconf/201822401135 | |
Published online | 30 October 2018 |
Adjustment of specialized technological equipment when machining small diameter internal threads with deforming cutting taps
Sevastopol State University, Department of Mechanical Engineering, 299053 Sevastopol, Russia
* Corresponding author: pasha_n2006@mail.ru
The article provides options for threading process diagnostics. For the previously proposed method of diagnostics, an algorithm for adjusting the machine, equipped with a pneumatic drive and a diagnostic module was developed. The interrelation between the technological system characteristics and the device for diagnostic signal recording was shown. As a result, it is possible to provide maximum productivity of the technological operation without the loss of processing quality.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.