Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 01129 | |
Number of page(s) | 6 | |
Section | Manufacturing Technologies, Tools and Equipment | |
DOI | https://doi.org/10.1051/matecconf/201822401129 | |
Published online | 30 October 2018 |
The relation between the geometric parameters of grinding powders grains measured by laser diffraction and light-microscopical methods
Volzhsky Polytechnic Institute (branch) of Volgograd State Technical University, “Technology and equipment of machine-building productions” Department, 42a Engelsa Street, Volzhsky, Volgograd region, 404121, Russia
* Corresponding author: nosenko@volpi.ru
The studies were conducted on grinding powders of black silicon carbide with F180-F60 grit produced by Volzhsky Abrasive Plant. The length, width, perimeter, area and reduced diameter of the grain area were determined by light-microscopical method, the equivalent diameter by the laser diffraction method. The distribution laws of geometric parameters are determined. A direct proportional relationship between the mean equivalent diameter and the average geometric parameters of the grain fractions (length, width, perimeter, equivalent diameter) and the power-law dependence with the average area of the grain fractions have been established
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.