Issue |
MATEC Web Conf.
Volume 224, 2018
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|
|
---|---|---|
Article Number | 01100 | |
Number of page(s) | 4 | |
Section | Manufacturing Technologies, Tools and Equipment | |
DOI | https://doi.org/10.1051/matecconf/201822401100 | |
Published online | 30 October 2018 |
Development of an algorithm for calculating the number of regrindings for a shaver with the continuous spiral cutting edge
Kazan Federal University, pr.Syuyumbike, d.10A, Naberezhnye Chelny, 423812, Russian Federation
* Corresponding author: a.n.gol@yandex.ru
There is a construction of tool of a worm type (shaver) at that a cutting wedge has the structurally performed clearance. In this case is possibility of the sequential processing of right and left side of profile of gear teeth of wheel different spiral cutting edges. It provides the increase of firmness of tool, diminishes auxiliary time, except the necessity of refixturing of wheel and promotes the productivity of process. For the effective use of shaver with spiral cutting edges it is important to define the exact meaning of amount of possible regrinds. An algorithm that allows to define the amount of possible regrinds of shaver is presented in the article.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.