| Issue |
MATEC Web Conf.
Volume 129, 2017
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|
|
|---|---|---|
| Article Number | 01043 | |
| Number of page(s) | 4 | |
| Section | Modern Manufacturing Technologies, Tools and Equipment | |
| DOI | https://doi.org/10.1051/matecconf/201712901043 | |
| Published online | 07 November 2017 | |
Determination of the profile of the worm-type tool
Kazan Federal University, pr.Syuyumbike, d.10A, Naberezhnye Chelny, 423812, Russian Federation
* Corresponding author: a.n.gol@yandex.ru
The cutting wedge of disk shaver at gear shaving has not fully satisfactory geometry: clearance The cutting wedge of the disk shaver when gear shaving is not fully geometrically satisfactory. The clearance on cutting edges are practically equal to zero. We would suggest this is the reason that the disk shavers machining of gear-wheels with large allowance is not possible. The construction of a worm-type tool is known also for clean machining of points of involute of gear-wheels made with continuous spiral cutting edges. The difference of this construction from the construction of N. Chemborisov is that a cutting wedge has the structurally made clearance α (Authors: N. Smorkalov, V. Skripin, V. Ptitcin, IU. Belugin). Polishing of side of coil is the most responsible and labor intensive operation when making a worm-type tool with the continuous spiral cutting edges of construction of N.Smorkalov and other.Dependences allowing to define the coordinates of key points of axial section of side of coil of the worm-type tool were obtained. These coordinates will allow to define the parameters of setting of abrasive disc in relation to the worm-type tool.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.