MATEC Web Conf.
Volume 224, 2018International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|Number of page(s)||5|
|Section||Manufacturing Technologies, Tools and Equipment|
|Published online||30 October 2018|
Model of control over cutting tool demand in a machining shop
Ulyanovsk State University, Department of Digital Economy, 432017 Ulyanovsk City, L’va Tolstogo st, h.42, Russian Federation
2 Ulyanovsk State University, Scientific Research Centre of CALS-technologies, 432017 Ulyanovsk City, L’va Tolstogo st, h.42, Russian Federation
3 Ulyanovsk State University, Department of Mathematical Modeling of Engineering Systems, 432017 Ulyanovsk City, L’va Tolstogo st, h.42, Russian Federation
* Corresponding author: firstname.lastname@example.org
The article proposes an optimization model of control over cutting tool demand in a machining shop. The model is based on application of one of the optimization problems, which occur at an enterprise depending on its current requirements: minimization of time and financial costs, and with convolution of these criteria. Furthermore, the work describes a software program used for calculation of required quantity of cutting tools necessary for meeting of production targets.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.