MATEC Web Conf.
Volume 224, 2018International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2018)
|Number of page(s)||6|
|Section||Manufacturing Technologies, Tools and Equipment|
|Published online||30 October 2018|
Magnetohydrodynamic pump application in complex form aluminum parts additive manufacturing
Volgograd State Technical University, Volgograd 400005, Lenin Avenue 28, Russia
* Corresponding author: Alexey.Drobotov@gmail.com
A review of Drop-on-Demand additive manufacturing methods was held. A method of complex forms aluminum parts production through the application of magnetohydrodynamic pump and 5 axis manufacturing process was proposed. 5 axis 3D printer assembly was shown. A few operation modes were proposed for such 3D printer and a method for fill lines paths calculating, needed for G-code automatic generation, was established. The algorithm for calculating printhead moving trajectory in the cylindrical parts manufacture mode was shown.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.